Flat Fine Screen with hydraulic drive

This type of screen has already been proven in hundreds of applications under severe operating conditions with channel widths of up to 2.5 m. Due to its individual design it is also possible to replace the screen gird with a modified gap width later during operation by simple means and low costs. The clear, reliable and user-friendly stainless steel design and the hydraulic capacity that can be achieved with this technical solution convince every expert.

This screen additionally guarantees lowest possible maintenance-level with respect to lubrication, adjusting, re-tensioning or replacement of wear parts.

• High hydraulic throughput and low hydraulic loss due 30° installation of the bar screen and use of total channel width
• No bearings, chains, brushes or deflection devices below the water level
• Easily detachable openings and hygienic containment
• Good visibility of the entire process
• Screening system with verifiable lowest malfunction and maintenance periods (German magazine Korrespondenz Abwasser, Abfall 2014 (61), issue 7, pp.613ff.)
• Extremely low operating costs
• Machine requires no on-site readjustment
• Scraper is the only expendable item (any wear and tear of the bar will automatically compensate)
• Very little wear and tear as the machine contains few moving parts (maintenance costs, spare parts)
• No sand deposits in front of screen caused by scraping at ground level
• No jamming/blockage of screen caused by solids
• Simple to retrofit existing channels (no recess required in the channel bed)
• Completely made out of stainless steel (to suit your requirements)
• Low machine height, easily accessibly
• Very brief assembly time and therefore only short downtime for the sewage plant
• Gap widths can easily be changed at a later stage, by replacing the bar screen (a job which takes approximately 15 minutes), without the need to involve special assembly staff

Broschüre downloaden

Bilder Flach-Feinsiebrechen mit Hydraulikantrieb